Honeywell Non Programmable Thermostat, 1H/1C 24v Digital - Large Display (UPGRADED)

Honeywell Non Programmable Thermostat, 1H/1C 24v Digital - Large Display (UPGRADED)
Code: T8400C1040A
Price: $79.88
Quantity in Basket: None
Quantity:
Untitled Document

Honeywell TH5110D Non-programmable Thermostat

*Part Number 50002883-001 - Cover Plate Included! (Med6.5x4.7, Lrg6x8.3")

APPLICATION

The TH5110D Non-programmable Thermostat provides electronic control of 24 Vac, single-stage heating and cooling systems or 750 mV heating systems.

MERCURY NOTICE
If this control is replacing a control that contains mercury in a sealed tube, do not place your old control in the trash. Contact your local waste management authority for instructions regarding recycling and the proper disposal of the old thermostat.

INSTALLATION
When installing this product…
1. Read these instructions carefully. Failure to follow these instructions can damage the product or cause a hazardous condition.
2. Check the ratings given in the instructions and on the product to make sure the product is suitable for your application.
3. Installer must be a trained, experienced service technician.
4. After completing installation, use these instructions to check out the product operation.

CAUTION
Electrical Hazard.
Can cause electrical shock or equipment damage.
Disconnect power before beginning installation.

Select Thermostat Location
Select a location for the thermostat about 5ft (1.5m)
above the floor in an area with good air circulation at
average temperature.

Do not install the thermostat where it can be affected by:
— Drafts or dead spots behind doors and in corners.
— Hot or cold air from ducts.
— Radiant heat from sun or appliances.
— Concealed pipes and chimneys.
— Unheated (uncooled) areas such as an outside wall behind the thermostat.

Separate Wallplate from Thermostat
1. Separate the wallplate from the thermostat.

Install Wallplate
Mount the thermostat horizontally on the wall:
1. Pull the wires through the wire hole on the wallplate.
2. Position the wallplate on the wall with the arrow pointing up. Level the wallplate for appearance only.
3. Use a pencil to mark the mounting holes.
4. Remove the wallplate from the wall and drill two 3/16-in. holes in the wall (if drywall) as marked. For firmer material such as plaster, drill two 7/32-in. holes. Tap the wall anchors (provided) into the drilled holes until flush with the wall.
5. Pull the wires through the wire hole on the wallplate and position the wallplate over the wall anchors.
6. Insert the mounting screws into the wall anchors and tighten.

WIRING
All wiring must comply with local electrical codes and ordinances.
CAUTION
Electrical Hazard. Can cause electrical shock or equipment damage. Disconnect power before wiring.
IMPORTANT
Use 18-22 gauge thermostat wire. Shielded cable is not required.
1. Loosen the screw terminals that are used for the application. Insert the wires into the terminal block and tighten each screw terminal.
2. Push excess wire back into the wall opening and restrict wires to the shaded area.
3. Plug the wall opening with nonflammable insulation to prevent drafts from affecting the thermostat.

NOTES:
1. When used in a single-transformer system, leave metal jumper in place between Rc and R. If used on a
two-transformer system, remove metal jumper between Rc and R.
2. Common wire is optional when thermostat is used with batteries.
3. If thermostat is configured for a heat pump in the Installer Setup, configure changeover valve
for cool (O-factory setting) or heat (B).

Replaces Part Numbers: TH5110D1022, T8400C1040, CARTH5110D1022, CART8400C1040