3 - Phase Line Voltage Monitor Protector 208/230 Volt to 600 Volts 3-Phase (LED)

3 - Phase Line Voltage Monitor Protector 208/230 Volt to 600 Volts 3-Phase (LED)
Code: PRS4067A
Price: $196.88
Quantity in Basket: None
Quantity:
Carrier, Bryant, Payne, Trane and many other brands use this Motor Protector:

• Identifies front and back side faults
• Built-in short cycle protection, knob adjustable delay on break, 0.1 to 5 minutes
• Monitors: voltage unbalance, high/low voltage, phase loss, reversal, incorrect sequencing, rapid short cycling

Input:

• Voltage: 190–630 Vac, 50/60 Hz
• Voltage unbalance: Adjustable 2–25%
• Control: 18–240 Vac

Output:

• Relay, SPDT—Normally open: 10 amps
Normally closed: 6 amps

Motor Protector Specifications:Heavy Duty Relay. Output - LED Fault Indication.Broad Operating Temperature Range. Epoxy Encapsulated Circuitry. Specifications: InputLine Voltage: 190-630 VAC 3-Phase Voltage Trip Point: +/- 12% fixed, 6% for resetVoltage Symmetry: 2-7% adjustableDeadband for Reset: 10% of Symmetry setpointControl Voltage: 18-240 VAC Output Ratings: SPDT-n.o. contact: 10 amps-n.c. contact: 6 amps Response TimesPhase Loss/Reversal: 100ms maximumUnbalance/High/Low: Full Selected Trip Delay PeriodOperating TemperatureRange: -40°C to +75°CLockout Delay Timer Input: 18-240 VAC/VDC RMS Time Delay: Adjustable to 5 minutes.Tolerance: +/- 20%Bypass Reduction: 24 VAC only: 1K @ 24VAC

Installation: 1.Disconnect Power2.Connect terminals in series with the device3.Reapply power and check operation. for complete diagrams, see installation guide Mode of Operation: Upon application of power of the three phase line and control voltage, the three phase lines are interrogated for proper phase sequence, symmetry and amplitude. Upon verification, thecontrol coil circuitry is energized and the line integrity once again verified on the load (back) side of the contactor.

Shouldno faults occur, the system will maintain its ON state. Relaces Part Numbers: AC-2020, AC-301, 29E58, MOD00756, AC-302, P251-0090, MOD00756, 29E58, M0D00756, CARICM400.

Designed To Protect Motors And Other Loads From Premature Failure And Damage Due To Common Voltage Faults Such As Voltage Unbalance, Over/Under Voltage, Phase Loss, Reversal, Incorrect Sequencing And Rapid Short Cycling.