3-Ton up to 9-1/2Ton Reversing Valve Solenoid Operated R22, R502 Refrigerant Suction: 7/8” Discharge
Quantity in Basket: None
Designed for unitary split systems and heat pump package units.
Brass body construction with copper tubes
Operates on pressure differential high and low sides of refrigerant systems.
,br> The way the reversing valve works is the solenoid valve opens pressure ports to operate a nylon slider in the cylinder. This sleeve can jam or bind half way (called "wind milling") and will over heat the compressor in a few minutes.
Once this happens there is little chance that the valve will work again. If the valve is over heated when being installed it will be worthless.
If the system is very contaminated after a Burn Out it may stop the valve form working but there is the possibility of getting it to work again after several cycles.
It is possible for the valve to stick in the cooling mode but it is more likely to stick in the heat mode.
Suction Diameter 7/8 Inch,
Discharge Diameter: 3/4 inch.
R 22 Capacity 3.0 to 9.5 Tons,
R 502 Capacity 2.75 to 7.7 Tons
4 Way, Coil Operated, Slide Type
Solenoid Included: NO
Reversing Valve Coils Optional per voltage:
Order Reversing Valve Solenoid Coil per operating Voltage:
Order 24 Volt Coils Part # RVVC32672
Order 120 Volts Coil Part # RVVC32673
Order 208/240 Volts Coil Part # RVVC32674
Replaces Part Numbers: V10-2750, V102750, CARB11266.
Used in Equipment Models: